Replacing The Device Fuse; Replacing The Plug Fuse (12/24 V); Replacing The Light Bulb - Waeco CF-18 Bedienungsanleitung

_CF-18_60.book Seite 41 Mittwoch, 17. Januar 2007 3:26 15
6.9

Replacing the device fuse

Only CF-35, CF-40, CF-50, CF-60
Caution – Danger of electrocution!
e
Disconnect the connection cable before you replace the device
fuse.
Pull off the connection cable.
Pry out the fuse insert (Fig. 6 2, page 4) with a screwdriver.
Replace the defective fuse with a new one that has the same
rating (T2,5AL 250V).
Press the fuse insert back into the housing.
6.10

Replacing the plug fuse (12/24 V)

Pull the adapter sleeve (Fig. 9 4, page 5) off of the plug.
Unscrew the screw (Fig. 9 5, page 5) out of the upper half of
the housing (Fig. 9 1, page 5).
Carefully raise the upper half of the housing from the lower
(Fig. 9 6, page 5) half.
Take out the contact pin (Fig. 9 3, page 5).
Replace the defective fuse (Fig. 9 2, page 5) with a new one
that has the same rating (8A 32V).
Re-assemble the plug in the reverse order.
6.11

Replacing the light bulb

Only CF-25, CF-35, CF-40, CF-50, CF-60
Press the switch pin (Fig. 0 2, page 5) downwards so that the
transparent part (Fig. 0 1, page 5) of the lamp can be removed
at the front.
Replace the light bulb.
Press the lamp back into the housing.
Operation
41