Denver 60cm (23,6") LCD-TV
Antenna connection
If you use a 75 Ohm coaxial cable (round cable) as an
antenna cable, connect the antenna plug directly to the
antenna input located on the TV. Motorized vehicles,
energy lines and telecommunication lines affect your
antenna. Therefore, be careful to install your antenna
away from these and metal surface in such a way that it
shall not swing. Do not make your antenna cable longer
than required and do not coil it. Make sure that it is not
crimped passing through a window or door. Your antenna
and cable might be affected by natural phenomena such
as rain, wind, smoke and humidity over time. Periodically
check your antenna and equipment.
Powering.on.your.device.and.the.initial.use
1. Insert the power cable into the appropriate power sup-
ply input located on the back panel of the LCD TV.
2. Insert the plug of the power cable supplied with the
device into the mains socket. Note 1: Your TV will
switch to the stand-by mode in five minutes if there is
no broadcast signal from antenna.
3. To power on your television, press STANDBY key on
the remote control.
Note: If you are not going to use your television for a long
time, unplug its power cable from the socket.
Initial.power.on.and.performing.settings
To set up your television, read the sections on the TV con-
trols and making the channel settings.
Batteries
Open the lid of the battery compartment and make sure
that you have placed the batteries in the correct direction.
For this remote control, UM-4, IEC R03 or AAA 1.5 V bat-
teries are suitable.
Do not throw your old batteries into the fire, discard them
in a dedicated waste area for this purpose.
Do not mix used batteries with new ones or different
types of batteries together.
The performance of the remote control will be reduced at
a distance of 8 meters from or at an angle of 30 degrees
beyond the center of the TV.
9