First Steps; Connecting External Equipment - Seg Denver Bedienungsanleitung

Denver 60cm (23,6") LCD-TV

FIRST STEPS

Follow the instructions below to correctly perform the initial configuration of the television set and remote control. In
subsequent pages you will find details of how to use the remote control and how to tune in channels.
1. Place the television set on a solid and completely horizontal surface.
2. Connect the antenna cable to the" RF" socket at the back side of the television set
3. Remote control:
Open the battery compartment. Insert the two batteries (type AAA 1.5V) supplied with the unit.
4. Power:
Plug the input socket of the power cable into the "AC IN " port at the backside of the television set.
Then, plug the other end of the cable into the power socket.
5. Turn on the television set:
Press the On/Stand-by (1) button on the remote control or at the front of the television set to turn
it on. The power light at the front of the set will turn green. When the television set is on Stand-by
mode the power light will be red.
6. Select Inputs:
TV/DTV/Media/AV/PC/YPBPR/SCART/HDMI
Press the Input button to display the inputs mode menu, then press / key to select a input source and press
Enter key to confirm.

Connecting External Equipment

You can connect a wide range of audio and video equipment to your TV.
NOTE: Refer to the manufacturer's guide for further-instructions on how to connect the equipment.
The following table lists a range of the available connectors on the TV.
Connector
HDMI IN
VGA IN
PC ADUIO IN
YPbPr COMPONENT IN
AV IN
SCART
RF IN
SD USB
COAX OUT
AC POWER SWITCH
Purpose
Receives High Quality HDMI input.
Receives the video signal from a PC.
Receives audio signal for PC mode.
Receives component video signal for YPBPR (Component) mode.
Receives composite video signal and audio signal for AV mode.
Receives a complete AV (Audio Visual) signal.
Receives TV signals from an external aerial.
Plays multimedia file
Coaxial Audio output
Headphone output
AC power on or off
5