Inserting/Replacing The Pre-Filter; Spare And Wearing Parts - ersa EASY ARM 1 Bedienungsanleitung

Maintenance/Spare and wearing parts
8.1.2

Inserting/replacing the pre-filter

9.

Spare and wearing parts

ersa EASY ARM 1
■
Make sure the device is switched off.
■
Open the cover of the extraction device by pressing the lugs on the hous-
ing side inwards.
■
Remove the pre-filter.
■
Note down the replacement/insertion date on the label of the filter.
■
Re-insert the new pre-filter with the white side facing up.
■
Re-attach the cover of the extraction device. Make sure that the lugs on
the housing side are both engaged again. The device is ready for use
again.
Designation
Omniflex extraction arm, 900 mm
Highflex extraction arm with joint, 700 mm
Highflex extraction arm, 1000 mm
Omniflex extraction arm with joint, 600 mm
Connecting hose, 2000 mm
Extraction nozzle, Ø 60mm, metallic, antistatic
3BA00216 • 2014-07-25 • Rev. 1
Order number
0CA10-4003
0CA10-4001
0CA10-4002
0CA10-4004
0CA10-2002
0CA10-5001*
25