Installation; Before The Installation; Built-In Hobs; Connection Cable - Electrolux EHXP8H10KK Benutzerinformation

Problem
E8 comes on.
E9 comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains
Possible cause
The electrical connection is
incorrect. The hob is con-
nected only to one phase.
There is an error of the in-
terface.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Attaching the seal to the
rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
3. Cut the ends of the stripes at an angle
4. Attach the stripes to the rabbets. Do
After you assemble the hob, seal the
remaining gap between glass ceramic and
the worktop with silicone. Make sure the
silicone does not get under the glass
ceramic.
Remedy
Speak to a qualified electri-
cian to check the installa-
tion. Refer to the connec-
tion diagram.
Deactivate the hob and ac-
tivate it again. If the mes-
sage comes on contact an
Authorised Service Centre.
stripes. The stripes must have the
same length as the rabbets.
of 45°. They should fit in the corners
of the rabbets accurately.
not extend the stripes. Do not bond
ends of stripes one over another.
ENGLISH 19