5. Slide the depth limiter ring (J)
into the hub with the toothed
side facing outside. Slide the
feed handle (G) assembly
into the hub and tighten with
a hex bolt M8x25 (H).
6. Clean out the tapered hole in the
drill chuck. Clean the spindle
nose with a clean cloth. Push
the drill chuck up on the spindle
nose as far as possible.
7. Place a piece of wood on the
drill table and move the feed
handle down. Lightly tap the
nose of the chuck with the piece
of wood to ensure proper fitting
of the chuck on the spindle.
Assembling
J
U
V
21
H
G