Disposal; Housse Scan Psa; Futerał Na Urządzenie Psa; Чехол Psa - Hilti PS 200 S Bedienungsanleitung

Message displayed
An exclamation mark in-
dicates either an error
caused by the operator
or an error that can be
en
solved by the operator.
Fault
The scanner doesn't start.
The scanner doesn't run freely.
The scanner operates only for
a short time before the battery
pack is exhausted.
The scan date and time are not
correct.
The date and time cannot be
set.

10 Disposal

WARNING
Improper disposal of the equipment may have serious consequences:
The burning of plastic components generates toxic fumes which may present a health hazard.
Batteries may explode if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution.
Careless disposal may permit unauthorized and improper use of the equipment. This may result in serious personal
injury, injury to third parties and pollution of the environment.
64
Fault
This symbol may appear
when trying to enter the
Imagescan or Blockscan
scanning mode, when try-
ing to begin a new Im-
agescan within Blockscan
scanning mode or when
trying to start Quickscan
recording.
Possible cause
The battery pack is not charged.
The contacts on the battery pack or in
the scanner are dirty.
The battery pack is old or defective,
or the maximum number of charging
cycles has been exceeded.
The wheels are dirty or dusty.
The drive belt or gear teeth are worn.
The battery pack is old or defective,
or the maximum number of charging
cycles has been exceeded.
The Hilti PROFIS Ferroscan applica-
tion was not used to set the date.
The date and time cannot be set as
no device driver was found.
Possible cause
This indicates that the
memory allocated to the
operation is full and that
no more data can be
stored.
Remedy
Change the battery.
Clean the contacts.
Contact Hilti Service.
Remove the wheels and casing and
clean the parts.
Contact Hilti Service.
Contact Hilti Service.
Install Hilti PROFIS Ferroscan V 5.7
(or a higher version) and start the ap-
plication.
Use the PSA 95 data cable to
connect the adapter and then go to
"Tools", "Workflow", "Set PSA 55
date and time" and set the current
date and time.
Install the driver manually: Use the
PSA 95 data cable to connect the
PSA 55 adapter to the computer.
Install the device driver
(Setup_PSA55.exe)
Remedy
In this situation, the data
must either be transferred
to the monitor or deleted
from scanner memory.
NOTE
Deleting the contents of
scanner memory may res-
ult in data loss. Data that
has not been transferred
to the monitor will be per-
manently deleted.