IKEA RENLIG DW55 Bedienungsanleitung Seite 7

ENGLISH
Indicator lights
1) The indicator light is off while a washing programme operates.
Delay start button
Use the delay start button to delay the start of
the washing programme with an interval of 3,
6 or 9 hours. Refer to the chapter 'Setting and
starting a washing programme'.
Function buttons
Use the function buttons for these operations:
• To set the water softener. Refer to the chap-
ter 'Setting the water softener'.
• To deactivate/activate the audible signals.
Refer to the section 'Audible signals'.
• To cancel the washing programme in pro-
gress or a delay start in progress. Refer to
the chapter 'Setting and starting a washing
programme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function buttons
A, B and C start to flash.
The indicator light comes on when the washing
programme is completed. Auxiliary functions:
• Level of the water softener.
• Activation/deactivation the audible signals.
• An alarm if the appliance has a malfunction.
4. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C starts
to flash.
– The end indicator light comes on.
The audible signals are activated.
5. Press the function button C again.
– The end indicator light goes off.
The audible signals are deactivated.
6. Switch off the appliance to save the oper-
ation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end in-
dicator light comes on.
Setting mode
The appliance is in setting mode when all the
programme indicator lights are on.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel the
programme to go back to the setting mode.
Refer to the chapter "Setting and starting a
washing programme".
7