Interrupting Operation - Kärcher HD 10/25-4 S Betriebsanleitung

Select spray type
 Close the hand spray gun.
 Turn the casing of the nozzle till the de-
sired symbol matches the marking.
 Select round or flat spray using touch-
less switching:
Turn the spray-pipe that is inclined about
45° downward to the left or the right.
Meaning of the symbols
High pressure flat spray
(25°) for large dirt areas
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray
(CHEM) for operating using
detergents or cleaning at
low pressure.
Operation with detergent
Warning
Unsuitable detergents can cause damage
to the appliance and to the object to be
cleaned. Use only those detergents that
have been approved by Kärcher. Observe
the dosage and other instructions provided
with these detergents. For considerate
treatment of the environment use detergent
economically.
Follow the safety instructions for using de-
tergents.
Kärcher detergents ensure smooth func-
tioning. Please consult us or ask for our cat-
alogue or our detergent information sheets.
 Fill detergent tank.
 Set nozzle to "CHEM".
 Set dosing value for detergent to the
desired concentration.
Detergent concentration [%] (for max. flow
quantity)
20
Position of the dos-
ing valve
Detergent concen-
tration [%]
(for max. flow
quantity)
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high-
pressure ray.
 After operations, dip the filter in clear
water. Turn the dosing valve to the
highest detergent concentration. Start
the appliance and rinse for one minute.

Interrupting operation

 Release the lever of the hand-spray
gun; the device will switch off.
 Release again the lever of the hand-
spray gun; the device will switch on
again.
Operational readiness period
On opening the hand-spray gun, the device
starts within the readiness period. The indi-
cator lamp glows green.
The readiness period is over if the hand-
spray gun remains closed for 30 minutes.
The indicator lamp blinks green.
Reset readiness period
 Set the appliance switch to "0".
 Wait for a while.
 Set the appliance switch to "I".
Customer Service can switch the device to
continuous operations.
– 5
EN
1 3 5 7
0,5 2,5 5,0 7,0