Herunterladen Inhalt Inhalt Diese Seite drucken

Steps To Be Taken In Case Of Blockage - Flow CUT BOX Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

17. Steps to be taken in case of blockage

ATTENTION!
When there is a blockage or fault, water sources which drain into the unit should
not be used.
>
Disconnect from electrical supply by withdrawing plug and ensure that it cannot
be inadvertantly reconnected
>
Remove cap seal (1) from tank
>
Insert a screwdriver or electrical drill and clear a possible blockage of the
cutting system by manually rotating the rotorshaft
If rotating the rotorshaft fails to clear the blockage then the complete motor/pum-
ping unit must be removed from the tank for inspection and the blockage cleared
by hand (see page 33, fig. 9).
ATTENTION!
Care must be taken when handling the motor/pumping unit as there is a danger of
injury from the cutting tool in the hydraulic system.
Steps to be taken in case of blockage
1
Figure 12
35

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis