Safety; Identification Of Hints In The Operating Instructions - Flow CUT BOX Betriebsanleitung

Safety | Identification of hints in the operating instructions

2. Safety

Extracted from VDMA-Standard-sheet 24292
VDMA = Verband Deutscher Maschinen- und Anlagenbau e.V.
These operating instructions contain basic information on installation, operating
and maintenance and should be followed carefully. For this reason it is essential
that these instructions are carefully read before installation and commissioning.
The operating instructions must always be available at the location of the unit.
In addition to the following safety regulations, it is also essential that the special
safety instructions given under other headings be observed.

3. Identification of hints in the operating instructions

The safety instructions given in this operating manual, the non-observance of
which could cause danger to life, are specifically highlighted with the general
danger symbol. See DIN 4844-W9.
The presence of a dangerous voltage is identified with the safety symbol.
See DIN 4844-W8.
ATTENTION!
Applies to safety instructions, the non-observance of which could damage the
unit or affect it's functioning.
Symbols directly on the unit itself, e. g.
>
Nameplate
must be carefully observed and must be maintained in a legible condition.
22