Vor Inbetriebnahme; Freezing Calendar; Bedienungs- Und Kontrolleinrichtung Kühlraum; Tasten Zur Temperatureinstellung - AEG SANTO C 9 18 45-5 i Gebrauchs- Und Einbauanweisung

Preparation of Ice Cubes
1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer com-
partment and leave to freeze.
2. To loosen the frozen cubes, either bend the ice cube tray or hold it under
running water for a few seconds.
Important! Never try to free an ice tray that is frozen to the freezer com-
partment using pointed or sharp edged objects. Use the ice scraper supplied.

Freezing Calendar

• The symbols on the drawers show
different types of frozen goods.
• The numbers indicate storage times
in months for the appropriate
types of frozen goods.
Whether the upper or lower value of the indicated storage time is valid
depends on the quality of the foods and pre-treating before freezing. The
lower value applies to foods with high fat content.
Defrosting
Refrigerator
Frost is automatically eliminated from
the evaporator of the refrigerator
compartment every time the motor
compressor stops, during normal use.
The defrost water drains out through a
trough into a special container at the
back of the appliance, over the motor
compressor, where it evaporates.
Freezer
The freezer compartment, however, will become progrssively covered with
frost. This should be removed with the special plastic scraper provided, whe-
never the tickness of the frost exceeds 4 mm. During this operation it is not
necessary to switch off the power supply or to remove the foodstuffs.
However when the ice becomes very thick on the inner liner, complete
defrosting should be carried out as follows:
40
D037
Z. B.: AC 220 ... 240 V 50 Hz oder
220 ... 240 V <~ 50 Hz
(d. h. 220 bis 240 Volt Wechselstrom, 50 Hertz)
Das Typschild befindet sich links im Innenraum des Gerätes.

Vor Inbetriebnahme

• Das Geräteinnere und alle Ausstattungsteile bitte vor Erstinbetriebnahme
reinigen (siehe Abschnitt "Reinigung und Pflege").
Bedienungs- und Kontrolleinrichtung
Kühlraum
°C °C
ON/OFF
A B C D E F G
A. Netzkontrollanzeige (grün)
B. ON/OFF Taste
C. Taste zur Temperatureinstellung (+)
D. Temperaturanzeige
E. Taste zur Temperatureinstellung (-)
F. Anzeige für eingeschaltete COOLMATIC Funktion (gelb)
G. COOLMATIC Taste

Tasten zur Temperatureinstellung

Die Temperatureinstellung erfolgt durch die Tasten C und E.
Die Tasten stehen in Verbindung mit der Temperaturanzeige.
• Durch Druck auf eine der beiden Tasten C oder E wird die Temperaturanzei-
ge von der IST-Temperatur (Temperaturanzeige leuchtet) auf die SOLL-Tem-
peratur (Temperaturanzeige blinkt) umgeschaltet.
°C °C ALARM OFF
ON/OFF
9