Preparations And Main Functions Camera Cable Length Setup - JVC RM-P210 Bedienungsanleitung

PREPARATIONS AND MAIN FUNCTIONS
CAMERA CABLE LENGTH SETUP
Cable length setup is required when a camera is connected to the RM-P210 for the first time or when
the camera cable length is changed. The cable length setup value is stored in the memory inside the
RM-P210 and is held even after it is turned OFF.
FULL AUTO F1
SHUTTER
2. CABLE
BARS
F2
GAIN
M
LCD display
Cursor
1.
1: GENLOCK
2: CABLE
Cursor
2.
2A: LENGTH
3.
2A: LENGTH
4.
2A: LENGTH
6.
2B: Y CABLE EQ
7.
2B: Y CABLE EQ
9.
2C: C CABLE EQ
10.
2C: C CABLE EQ
MENU/SHUTTER GAIN
F3 P
STEP
HIGH
SHUTTER VARIABLE MID
PUSH-ON PUSH-ON
R
F4 MENU
LOW
DOWN UP DOWN UP
Control knob
MENU button
5M
Setting
5M
100M
NORMAL
127
NORMAL
1
1.
Press and hold the MENU button for about 1 second until
the LCD display shows the menu display. Turn the con-
trol knob to move the cursor ( ) to "2: CABLE".
2.
Press the control knob to display "2A: LENGTH".
Setting the cable length
3.
Press the control knob to move the cursor ( ) to the cur-
rently set length.
4.
Turn the control knob to select the cable length that is to
be used in meters (variable to 5M, 20M, 50M or 100M).
5.
After setting the value, press the control knob to move the
cursor ( ) back to "2A: LENGTH".
Fine adjusting the Y (luminance) signal level
6.
Turn the control knob to move the cursor ( ) to "2B: Y
CABLE EQ", then press the control knob to move the
cursor ( ) to the currently set value.
7.
Turn the control knob to fine adjust the Y level (variable
from -128 to NORMAL and up to 127).
8.
After setting the value, press the control knob to move the
cursor ( ) back to "2A: LENGTH".
Fine adjusting the C (Chrominance) signal level
9.
Turn the control knob to move the cursor ( ) to "2C: C
CABLE EQ", then press the control knob to move the
cursor ( ) to the currently set value.
10 .
Turn the control knob to fine adjust the C level (variable
from -128 to NORMAL and up to 127).
11 .
After setting the cable length, Y level and C level, press
the MENU button to return to the previous display.
NOTE
When the above adjustment is performed, the colour
phase (subcarrier phase = SC) varies.
E-11