Special Accessories - AEG DD8692-M Benutzerinformation

• Replacing
Take off the metal grease filter and
remove the activated charcoal
filter from its housing by turning
the clips provided. Fit the new
activated charcoal filter and
replace the metal grease filter.
• Enabling the alarm signal
In recirculation type hoods the
saturated filters alarm must be
enabled as indicated below:
• Turn off the lights L and the Suction Motor V1;
• Press and hold the button V3 for at least 10 seconds, until the Leds start to flash.
Note the number of flashes:
- 2 flashes of the LED Activated charcoal filter saturation alarm ENABLED
- 1 flash of the LED Activated charcoal filter saturation alarm DISABLED
• Resetting the alarm signal
To turn the alarm signal off, proceed as follows:
- Press the button V3 for at least 3 seconds, until the Leds flash in confirmation. In any
case the saturated filters alarm will only come into operation when the suction motor is
turned on.
ATTENTION - There could be a possible fire hazard if the filters are not replaced
according to these instructions.
Lighting
1 - It consists of 2 20 W-halogen spotlights.
2 - Replacement
Remove the two screws that lock the metal
ring, take the spotlight out of its holder by
pulling slightly. When replacing, make sure
that both pins are well inserted in the holder
seat.

Special accessories

Wall housing MKZ 125
External dimensions
Wall aperture
Outlet duct ABS 120
Ø 120 mm aluminium
Outlet duct ABS 125
Ø 125 mm aluminium
Serial no. 610 899 004
Height x width in mm
250 x 220
185 x 210
Serial no. 942 118 611
Serial no. 942 118 612
Instructions for use
S07_31
39