Installing The (Optional) Antenna; Installing The Belt Clip - Kenwood NX-5200 Benutzerhandbuch

INSTALLING THE (OPTIONAL) ANTENNA

Screw the antenna into the connector
on the top of the transceiver by holding
the antenna at its base and turning it
clockwise until secure.

INSTALLING THE BELT CLIP

If necessary, attach the belt clip
using the two supplied M3 x 8 mm
binding screws.
Note:
• If the belt clip is not installed, its
mounting location may get hot
uring continuous transmission
or when left sitting in a hot
environment.
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver's back panel.
14
Optional
antenna
Belt clip
M3 x 8 mm
screws