Wiring Connection - Kenwood KDC-320UI Bedlenungsanleitung

INSTALLATION/CONNECTION

Wiring connection

Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
A4 Yellow : Battery
Blue/White * 1
A5 : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
Purple ]
B1
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
B2 Purple/black [
B3 Gray ]
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
Gray/black [
B4
White ]
B5
: Front speaker (left)
For 3-way crossover: Mid range speaker (left)
White/black [
B6
B7 Green ]
: Rear speaker (left)
For 3-way crossover: Tweeter (left)
B8 Green/black [
30
ENGLISH
Antenna terminal
Ignition wire (Red)
Unit
Battery wire (Yellow)
Fuse (10 A)
If no connections are made, do not let the wire come out from the tab.
Yellow (Battery wire)
Light blue/yellow
Red (Ignition wire)
(Steering remote
control wire)
Red (A7)
Blue/White *
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
ISO connectors
NOTE: Total output for Blue/White wire
( * 1
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and leave
this job to professionals for your safety. Consult your car audio
dealer.
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
STEERING WHEEL
REMOTE INPUT
To the steering wheel remote control
REMOTE CONT
adapter
To the power control terminal when
2
ANT CONT
using the optional power amplifier
P. CONT
or to the antenna control terminal in
the vehicle
To connect the Kenwood navigation
system, refer your navigation manual
(For
MUTE
To the terminal that is grounded
when the telephone rings or during
conversation. ( 24)
) + ( * 2
) is 12 V 350 mA
)