Whirlpool AMD 054 Gebrauchsanweisung Seite 51

4. Connecting the Cable
• Indoor Unit
1) Open the front panel, remove the covering
plate by loosening the screw.
2) Connect the power connecting cord to the
indoor unit by connecting the wires to the
terminals on the control board individually as
follows.
3) Secure the power connecting cord on the
control board with cable clamp.
4) Refit the covering plate and tighten the screw.
NOTE: (depending on the model)
It is necessary to remove the cabinet to perform
connections with the indoor unit terminal.
• Outdoor Unit
1) Remove the access door from the unit by
loosening the screw. Connect the wires to
the terminals on the control board individually
in accordance with the indoor unit
connection.
2) Secure the power connecting cord on the
control board with cable clamp.
3) Refit the access door in the original
position and tighten the screw.
CAUTION:
1. Make sure that the colour of wires and the terminal number of the outdoor unit are the same as those
of the indoor unit.
2. Use an individual power circuit specifically for the air conditioner. As for the wiring method, refer to
the circuit diagram on the appliance.
3. Check that the cable specification conforms to the table as follows.
4. Check the wires and make sure that they are all tightly fastened after cable connection.
The cable should be tighly fastened by cable clamp.
5. Be sure to install an earth leakage circuit breaker in a wet or moist area.
Cable Specifications
Capacity
Type
(Btu/h)
Inverter
12k
Power cord
9k H05VV-F, 3G 1.5 mm²
H05VV-F, 3G 1.5 mm²
Covering plate
access door
Power connecting cable
H07RN-F, 4G 1.5 mm²
H07RN-F, 4G 1.5 mm²
51
Blue
Black
Yellow
-Green
Brown
Power
connection
Cable Clamp
cable
Blue
Yellow-Green
Black Brown
Power
Cable Clamp
connection
cable
Main power
supply (Note)
To indoor
To indoor