Whirlpool AMD 054 Gebrauchsanweisung Seite 39

JET and LIGHT functions
Each time the JET (Light) button is is pressed, the
operation status is changed in sequence:
• Under COOLING and HEATING mode:
JETon / LIGHTon
JEToff / LIGHTon
• Under other mode:
LIGHToff
LIGHTon
Note:
Each time the batteries are replaced in the remote
control, the RC is pre-set at Light on.
JET mode
• JET mode is used to start or stop fast cooling or
fast heating.
will display on remote control under this
mode. The appliance will blow at super high fan
speed to cool or heat your room quickly and
effectively.
• In JET mode, you can set temperature and
airflow direction
Note:
• Jet function is not available in 6th Sense, Fan
only, and Dehumidifying mode.
• When switching the mode or changing fan
speed, this function will be canceled
automatically.
LIGHT Function
Press this button to turn on or turn off display light
on indoor unit control panel.
You can press this button to turn off the running
indicator light when the appliance is off.
will display on remote control when front panel
display lights up.
CLOCK function
You can set clock by pressing CLOCK button, then
using + and – buttons to set the correct time,
press CLOCK button again, the clock is set.
Pressing CLOCK button, signal
seconds, the value can be adjusted
+ Press once to raise time setting by 1 minute
– Press once to lower time setting by 1 minute
if continuously press + or – buttons, the number
will change rapidly.
12:00 is the default time to display after inserting
batteries.
JEToff / LIGHTon
JEToff / LIGHToff
blink. Within 5
39
SLEEP mode
This function gives you a more comfortable
environment for sleep. There are 3 sleep modes
for your choice.
Each time this button is is pressed, the operation
status is changed in sequence:
STANDARD SLEEP
SLEEP mode off
STANDARD SLEEP mode
will display on remote control during this
1
mode.
• When you set this mode under COOLING
or DEHUMIDIFYING operation, the
appliance will let the set temperature raise
for 1°C for the first hour and another 1°C for
the second hour, then remain constant.
• When you set this mode under HEATING
operation,the appliance will let the set
temperature lower 1°C for the first hour and
another 1°C for the second hour, then
remain constant.
6th SENSE SLEEP mode
will display on remote control during this
2
mode.
The appliance will change the set temperature
automatically according to the actual room
temperature
6th SENSE SLEEP
DIY SLEEP