Privileg PCCF 80211250 X Gebrauchsanweisung Seite 32

POSITIONING
Your electric cooker is designed for standard household
use. The cooker can be installed in housing units
without gaps at the sides (minimum width 500 mm).
Adjacent units must be heat-resistant to 100°C or
covered with heat-insulating panels.
The cooker must not be installed on a plinth. The
manufacturer recommends that after installation, there
be a minimum distance of 650 mm between the cooker
and any cooker hood.
LEVELLING THE APPLIANCE
The cooker is equipped with 4 adjustable screws which
enable the cooktop to be fixed at the desired height or
the appliance to be levelled.
PROCEDURE:
• Remove any oven accessories;
• Tilt the cooker onto its side;
• Screw the plastic screws into the front and rear
holes on the underside of the bottom crossbar on one side;
• Tilt the cooker onto the opposite side and insert the screws into the openings there;
• Level the cooker using a screwdriver, gaining access from the storage area, or using an Allen key.
NOTE:
Levelling screws need not be fitted if the height of the appliance is acceptable and it is also level.
NOTE:
The manufacturer reserves the right to make minor modifications to the instructions due to
technological or innovative changes to the appliance, which do not impact the functioning of the
latter.
32