Werbung
COPIER TROUBLE?
Problem
Copier does not
operate.
Copies are too dark
or too light.
Blank copies.
Copies smear if
rubbed.
Paper misfeeds
frequently.
Dust, dirt, smudges
appear on copies.
Power is on but
copying is not
possible.
Please contact your authorised Sharp Service Centre immediately if a problem persists after checking the above.
3 – 26
SF 2218 NON EU GB+D.p65
Copier plugged in?
Power switch ON?
Copy density properly adjusted?
Is the original placed face down?
Paper too heavy?
Paper damp?
Non-standard paper used?
Paper properly installed?
Pieces of paper inside copier?
Paper curled or damp?
Document glass or document
cover dirty?
Original smudged or blotchy?
d
Is the
indicator on?
Is the copy m indicator on?
Is the m indicator blinking?
Is the power save indicator blinking?
i i i i i
Is only the POWER SAVE (
indicator on?
Is
steadily lit in the copy quantity
display?
x
Is the
indicator on?
:
:
:
:
:
Has a blinking
appeared in the
copy quantity display?
Is
steadily lit in the copy quantity
display?
Is the t indicator blinking?
Is the j indicator blinking?
Is the front cover firmly closed?
26
Solution
Plug the copier into a grounded outlet.
Turn the power switch ON.
See page 3-14.
Place the original face down on the docu-
ment glass.
Use copy paper within the specified range.
See page 3-28.
Replace with dry copy paper. See page 3-28.
Use standard paper. See pages 3-11 and 3-28.
Make sure the paper is properly installed.
See pages 3-3 and 3-11.
Remove all pieces of misfed paper. See
page 3-16.
Store copy paper flat in the wrapper in a
dry location. See page 3-28.
Clean regularly. See page 3-25.
Use a clean original.
Developer is required. Contact your Sharp
Service Centre as soon as possible. See
page 3-25.
Maintenance is required. Contact your
Sharp Service Centre as soon as possible.
See page 3-25.
Wait until warm-up is complete.
Warm-up time is 35 seconds.
)
The copier is in the auto power shut-off
mode. Press the print (
page 3-24.
The copier is in the auditing mode.
Enter your account number using the
10-key pad. See page 3-15.
Copy paper is needed. See page 3-3.
1. Paper has run out in the optional multi
bypass feeder. Add paper to continue.
2. Paper has failed to feed from the optional
multi bypass feeder. See page 3-12.
1.The optional sorter or staple sorter is
not latched to the copier. Slide the sorter
or staple sorter toward the copier to latch
it into place.
2.The stapler cover of the optional staple
sorter is open. Close the stapler cover.
Toner is required. See page 3-5.
A misfeed has occurred. See page 3-16.
Close the front cover firmly.
27/08/99, 08:38
z
z
z
z
z
) button. See
Werbung
Kapitel
