Linea 2000 DOMO DO7300S Gebrauchsanleitung Seite 73

ROTATING BRUSH
1. Remove the cover on the underside of the robot vacuum cleaner by pressing the small release
button. Remove the rotating floor brush by first sliding the brush and its holder to the left and
then rotating them upwards. You can then easily pull the floor brush off its mounting shaft.
2. Wipe the cover clean with a soft cloth. Remove hair and other debris wrapped around the floor
brush.
3. Rinse the brush under running water and allow it to dry completely before refitting it.
4. Reattach the floor brush to its mounting shaft, rotate the brush and its holder back down into
the robot vacuum cleaner and slide them fully to the right. Refit the cover by securing the right
side first and then pressing down the left side.
1
If the floor brush is not cleaned regularly, it may become damaged and the appliance may become
unusable.
MOPPING PADS, SIDE BRUSH AND WHEELS
Remove the side brush and mopping pads from the appliance.
Wipe the side brush, mop holders and wheels clean using a soft cloth.
3
www.domo-elektro.be 73