Linea 2000 DOMO DO7300S Gebrauchsanleitung Seite 68

CHARGING
Switch on the robot vacuum cleaner by pressing and holding the on/off button for a few seconds.
Make sure that the charging and emptying station is correctly installed.
Press the charging button on the appliance. The robot will drive to the charging and emptying
station and start charging.
NOTES:
• Before first use, allow the robot vacuum cleaner to charge fully for 12 hours.
• When the battery is almost empty, or when the robot has finished its programme, the appliance
will automatically return to the charging and emptying station to recharge. If no charging and
emptying station is installed, the robot vacuum cleaner will switch to standby mode.
• Make sure the appliance is always switched on, otherwise it will not be able to charge.
• Ensure that the charging and emptying station is always plugged into a mains socket;
otherwise, the robot vacuum cleaner will not be able to locate the station.
• You can also choose to charge the appliance earlier by pressing the charging button on the
appliance or selecting "Charge" in the app.
• If the appliance's battery is completely empty, you can place the robot manually into the
charging and emptying station.
• During charging, the indicator lights on both the robot vacuum cleaner and the station will
switch on and off. When the indicator lights remain continuously lit, the appliance is fully
charged.
USE
The robot vacuum cleaner maps the room using a laser beam, allowing it to clean the area in the
most efficient way possible. It cleans by zone, first along the edges and then in a zigzag pattern
to ensure systematic and efficient operation. In addition, its sensors prevent it from colliding
with obstacles. It is recommended to tidy up the room as much as possible and remove as many
obstacles as you can. Open the doors of the rooms that need to be cleaned.
68 www.domo-elektro.be