Introduction; Device Description (Fig. 1-5); Scope Of Delivery; Intended Use - Scheppach 5906504901 Originalbetriebsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of
application.
Keep the operating manual in a good place and hand
over all documents when passing the product on to
third parties.

2. Device description (fig. 1-5)

1. Handle
1a. Support foot (left)
1b. Support foot (right)
1c. M6x10 mm Phillips screw
2. Wheels
22 | GB
2a. Wheel axle
2b. Safety splints
2c. Hexagonal bolts
3. Housing door
4. Air inlet
5. LCD display
6. Drain hose
6a. Hose clamp
7. Water tank
7a. Plug
LCD display
A. Dehumidification mode
B. Level indicator
C. Automatic defrosting
D. Speed display
E. Operating hours counter
F. Adjust speed
G. Reduce target humidity
H. Increase target humidity
I. On/off switch
J. Ambient humidity display

3. Scope of delivery

Quantity
1x
1x
2x
2x
2x
2x
8x
1x
1x
1x
1x

4. Intended use

The device is intended for 230 V AC voltage devices.
The construction dryer is only suitable for indoor use,
for drying damp walls, after water damage or for redu-
cing the humidity in closed rooms larger than 10.1 m².
www.scheppach.com
Designation
Wheel axle
Handle
Wheels
Hexagonal bolts
Split pins
Support feet
M6x10 mm Phillips screw
Drain hose
Hose clamp
Water tank
Operating manual