Troubleshooting; Possible Cause - Scheppach Hl760L Originalbetriebsanleitung

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in
an environmentally friendly manner.

17. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
When returning the product for repair, for safety reasons, ensure that it is free of oil and fuel when it is sent to the
service centre.
Problem
Motor stops starting
Fails to split logs
Log pusher moves jerkily,
taking unfamiliar noise or
vibrating a lot
Oil leaks around the
cylinder ram or from other
points
30 | GB

Possible Cause

Overload protection device disengaged to protect
the log splitter from being damaged
Log is improperly positioned
Size of log exceeds the capacity of the machine
Wedge cutting edge is blunt
Oil leaks
Lack of hydraulic oil and excessive air in the
hydraulic system
Air sealed in hydraulic system while operating
Bleed screw is not tightened before moving the
log splitter
Oil drain screw loose
Hydraulic control valve assembly and/or seal (s) worn Contact your dealer
www.scheppach.com
Remedy
Contact a qualified
Electrician.
Refer to "operation" section to
perfect log loading
Reduce log size before
operating
Sharpen cutting edge
Locate leak(s) and contact
your dealer
Check oil level for possible
refilling. Contact your dealer
Loosen bleed screw by some
rotations before operating the
log splitter
Tighten bleed screw up
before moving the log splitter
Tighten the oil drain screw
firmly