Hama EWS-165 Bedienungsanleitung Seite 2

A
20
1
8
2
3
9
4
5 10
6
11
12
7
13
15
14 16
17 19
18
B
24
G Operating instruction
Controls and Displays
A Base station
1. Measuring station wireless symbol
2. Channel display
3. Outdoor temperature
4. Room temperature
5. Wireless symbol
21 6. Time zone
7. Day
8. Outdoor temperature trend
9. Room temperature trend
10. Time
11. Weekday / seconds
12. Alarm symbol
13. Month
14.  button
23
= reducing the current setting / manually searching for
the signal from the measuring station
15. CHANNEL button
= channel selection
16. ▲ button
= increasing the current setting / activating/ deactivating
22
manual radio signal reception
17. MODE button
= Einstellungen / Bestätigung des Einstellungswerts
/ Wechsel zwischen Sekunden-, Wochentag- und
Zeitzonenanzeige
18. ALARM ON/OFF button
= display / setting alarm modes
19. MEM button
= accessing/ resetting the stored maximum/minimum
values
20. SNOOZE button
= stops the alarm
25
21. Opening for wall mounting
26
22. Base
23. Battery compartment
27
28
B Measuring station
24. Battery compartment
25. Mounting plate
26. Cut-out for vertical mounting
27. Cut-out for horizontal mounting
28. Clips
2
Thank you for choosing a Hama product. • Keep the packaging material out of the reach of children
Take your time and read the following instructions and due to the risk of suffocation.
information completely. Please keep these instructions in a • Dispose of packaging material immediately according to
safe place for future reference. If you sell the device, please locally applicable regulations.
pass these operating instructions on to the new owner. • Do not modify the product in any way. Doing so voids the
warranty.
1. Explanation of Warning Symbols and Notes
Warning
• Immediately remove and dispose of dead batteries from
This symbol is used to indicate safety instructions or to
draw your attention to specific hazards and risks. • Only use batteries (or rechargeable batteries) that
• Do not mix old and new batteries or batteries of a
Note
• When inserting batteries, note the correct polarity (+
This symbol is used to indicate additional information or
important notes.
• Do not charge batteries.
2. Package Contents
• Keep batteries out of the reach of children.
• Weather station EWS-165
• Do not short circuit the batteries/rechargeable batteries
(base station for indoor/outdoor measuring station)
• Base
• 2 x AAA batteries
4. Getting Started
• 2 x AA batteries
• These operating instructions
4.1. Inserting the batteries
3. Safety Instructions
Measuring station
• The product is intended for private, non-commercial use • Open the battery compartment (24) and remove the
only.
contact breaker. Replace the battery compartment cover.
• Do not operate the product outside the power limits given
Base station
in the specifications.
• Open the battery compartment (23) and remove the
• Do not use the product in moist environments and avoid
contact breaker. Replace the battery compartment cover.
splashes.
• Do not use the product in the immediate vicinity of heaters
4.2. Replacing the batteries
or other heat sources or in direct sunlight.
• Do not use the product in areas where the use of electronic Measuring station
devices is not permitted.
• Open the battery compartment (24), remove and properly
• Do not place the product near interference fields, metal
dispose of the dead batteries and insert two new AAA
frames, computers, TVs, etc. Electronic devices and window
batteries with the correct polarity. Replace the battery
frames can negatively affect the product's functionality.
compartment cover.
• Do not drop the product and do not expose it to any
Base station
major shocks.
• Open the battery compartment (23), remove and properly
• Do not open the device or continue to operate it if it
dispose of the dead batteries and insert two new AA
becomes damaged.
batteries with the correct polarity. Replace the battery
• Do not attempt to service or repair the product yourself.
compartment cover.
Leave any and all service work to qualified experts.
Note
Before use, ensure you insert the batteries in the
measuring station first and then in the base station.
5. Installation
Warning – Batteries
Note – Installation
the product.
• We recommend initially placing the base and
measuring stations in the intended locations without
match the specified type.
installing them and making all the settings described in
6. Operation – to do.
different type or make.
• Only install the stations once the appropriate settings
have been made and a stable wireless connection is
and - markings) and insert
established.
the batteries accordingly. Failure to do so could result in
the batteries leaking or exploding.
Note
• The wireless transmission range between the measuring
and keep them away from uncoated metal objects.
and base stations is up to 30 m in open spaces.
• Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is
sufficient reception between the intended installation
locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could
damage the product.
• Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
3