Auto Shut-Off - Bosch Sensixx B35L PremierPower Gebrauchsanleitung

Energy saving "eco"
setting
(model dependent)
If the "eco" steam setting on the steam control
(5*) is selected, the energy consumption of the
appliance will be reduced, by means of the
reduction of water consumption and electricity.
A good ironing result can be obtained for most
garments.
Use higher settings only for thick and highly
wrinkled fabrics.

Auto shut-off

(model dependent)
If during ironing, the steam release button
(12-13*) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The "auto shut-off" pilot lamp (4) will flash when
auto shut-off has been activated.
To switch the steam station back on, press the
steam release button again.
fabric protection
4
soleplate cover
(model dependent)
The fabric-protection soleplate cover (15*) is
used for steam-ironing delicate garments at
maximum temperature without damaging them.
Use of the soleplate cover also does away with
the need for a cloth to prevent shine on dark
materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it fits tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be
purchased from our customer service or from our
website.
Accessory code
(After-sales)
00571510
18
B O SC H
Name of accessory
(online shop)
TDZ2045
5
Calc'n'Clean
Cleaning the Boiler
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the boiler after several hours of use
(approximately after 50 hours). If the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check carefully that the appliance is cold and
unplugged for more than 2 hours, and that the
water tank (1) is empty.
2. Place your appliance on the edge of your
kitchen sink.
3. Remove the plastic cover located on the
bottom of the appliance by turning it to the
position.
4. Unscrew the boiler drainage plug using a coin.
5. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water.
6. Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
To obtain the best result, we recommend that
this operation is done twice.
important: before re-closing, make sure no
water remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin.
8. Insert and close the plastic cover by turning it
to the position.
Automatic clean warning
(model dependent)
Pilot light (6) will flash indicating that boiler must
be rinsed.
To reset the "Calc'n'Clean" counter, switch
the steam station off twice, keeping it off for
at least 30 seconds each time.
(on → 30s off → on → 30s off → on)
* Model dependent