Setup; Scope Of Delivery; Mains Connection; Connection Of Peripheral Devices - KERN PLJ 600-2GM Betriebsanleitung

6.2.1 Setup

6.2.2 Scope of delivery

Serial accessories:
• Balance
• Weighing plate
• Mains power supply
• Operating Manual
• Protective cover
• Hook for underfloor weighing (only model PLJ 6000-1GM)

6.3 Mains connection

Power is supplied via the external mains adapter. The stated voltage value must be
the same as the local voltage. Only use original KERN mains adapters. Using other
makes requires consent by KERN.

6.4 Connection of peripheral devices

Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they
are ideally tuned to your balance.

6.5 Initial Commissioning

In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1).
During this warming up time the balance must be connected to the power supply
(mains, accumulator or battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.

6.5.1 Stability display

If the display shows the stability display [
status is instable the [
PLJ-GM-BA-e-1614
Level balance with foot screws until the air bubble of the
water balance is in the prescribed circle.
] the balance is in a stable status. If the
] display disappears.
11