Operation; Switching On/Off; Working Instructions; Regular Cuts - Parkside Pasa 20-Li D3 Bedienungsanleitung Und Originalbetriebsanleitung

˜ Operation
˜ Switching on/off
CAUTION! Risk of injury!
m
Always wear protective gloves
when handling or working with
the product .
CAUTION! Risk of injury!
m
Before switching on the product:
u
Ensure the saw blade
contact with the workpiece .
Ensure your stance is stable .
u
Always hold the product firmly with
both hands while working .
Keep your hands away from the
u
saw blade when the product is
[ 6 ]
in operation .
NOTE
You cannot lock the on/off
u
switch for continuous operation .
[ 5 ]
Switching on
1 . Release the switch lock
pushing it in on the left or right side .
2 . Press and hold the on/off switch
3 . Regulate the speed as required by
changing the amount of pressure on
the on/off switch
Switching off
1 . Release the on/off switch
2 . When releasing the on/off switch
the switch lock
its original position .
˜ Working instructions
CAUTION! Risk of injury and
m
damage to property!
Wear protective gloves when
u
handling the saw blade
way, you avoid injury from cuts .
16 GB/CY
is not in
6 ] [
by
[ 1 ]
5 ] [
.
5 ] [
.
5 ] [
5 ] [
moves back into
1 ] [
. In this
6 ] [
CAUTION! Risk of injury and
m
damage to property!
Do not use any blunt or bent saw
u
blades or saw blades which are
damaged in any other way .
Before sawing the workpiece,
u
check for hidden foreign objects
such as nails and screws and
remove them .
Always insert a suitable saw blade .
u
Secure the workpiece with the
u
aid of clamping devices on the
workbench .
Apply only as much pressure as
u
is required for sawing . If there is
excessive pressure, the saw blade
may bend and break .
Switch the product off immediately
u
if the saw blade jams . Try to spread
the saw cut and carefully pull the
saw blade out .
Always stand to the side of the
u
product when working .
Always make sure that the
u
workplace is well ventilated .
.
Avoid over-stressing the product
u
while working .
˜ Regular cuts
1 . Verify the saw blade
touching the workpiece .
,
2 . Switch the product on .
3 . Apply the base plate
workpiece .
4 . Use even pressure, advancing at a
steady pace when making the cut .
You can make horizontal, diagonal,
or vertical cuts (Fig. E).
5 . When working with the grip
bracket
11 ] [
downwards while applying light
pressure (Fig. G).
is not
6 ] [
to the
7 ] [
, move the product