Baltic 150N Gebrauchsanweisung Seite 12

ENGLISH
REARMING – AUTOMATIC VERSION
After manual or automatic infl ation.
Unscrew the cartridge anticlockwise
1.
is missing, the cartridge must be discarded and a new one fi tted. Follow the instructions on the
label next to the infl ation mechanism. Check the expiry date
cartridge must be discarded if it has passed the expiry date stamped on the side of the cart-
ridge (e.g. 02 2011 means that it must be replaced before February 2011).
Screw in the new cartridge clockwise, and tighten it fi rmly by hand until no threads are visible.
2.
Hold the mechanism fi rmly and unscrew the used CO
3.
sponsibly. Check that the lever and the cutter is moving freely
cord. The cutter should be visible at the bottom of the thread when the lever is pulled out. Push
the lever back in to the normal position and secure it with a new green safety indicator
Check visually that the o-ring at the bottom of the thread is undamaged
4.
Fit a new unpierced CO
5.
CO cylinder is correctly screwed in.
2
REARMING – MANUAL VERSION
Hold the mechanism fi rmly and unscrew the used CO
1.
responsibly.
Check that the lever and the cutter is moving freely
2.
cutter should be visible at the bottom of the thread when the lever is pulled out. Push the lever
back in to the normal position and secure it with a new green safety indicator
Check visually that the o-ring at the bottom of the thread is undamaged
3.
12
Fit a new unpierced CO
4.
CO cylinder is correctly screwed in.
2
REPACKING
BEFORE REPACKING
Follow the below instructions carefully.
•
Repacking must be carried out with dry hands, in a dry environment and without the use
•
of any tools.
Place the life jacket on its back on a fl at surface.
•
Make sure that all the air has been expelled from the lifejacket and that the oral infl ation tube
•
cap is in the normal position. Ensure that the lifejacket is rearmed as per instructions and that
the green safety indicators are in place
. If the green safety indicator
13
cylinder by fi rmly screwing it in clockwise. Use no tools. Ensure that the
2
cylinder by fi rmly screwing it in clockwise. Use no tools. Ensure that the
2
/
7
14
on the new cartridge. The
8
cylinder anticlockwise and discard re-
2
when pulling the activating
15:1
15:3
cylinder anticlockwise
2
when pulling the activating cord. The
15:1
15:3
/ / .
9 10 11
on the cartridge
.
15:2
.
and discard
6
.
15:2
.