Layout And Items Supplied; Supplied Package; Intended Use; Technical Data - EINHELL BT-BC 2 D Originalbetriebsanleitung

Anleitung_BT_BC_2_D_SPK7:_
This equipment is not designed to be used by people
(including children) with limited physical, sensory or
mental capacities or those with no experience and/or
knowledge unless they are supervised by a person
who is responsible for their safety or they have
received instructions from such a person in how to
use the equipment safely. Children must always be
supervised in order to ensure that they do not play
with the equipment.
CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Waste disposal
Batteries: Only dispose of these items through motor
vehicle workshops, special collection points or
special waste collection points. Ask your local
council.
2. Layout and items supplied (Figure 1)
2.1 Layout
1 Charger clamp, black (-)
2 Charger clamp, red (+)
3 Mains cable

2.2 Supplied package

Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Battery charger
Original operating instructions
25.05.2010 9:08 Uhr Seite 13

3. Intended use

The charger is designed for charging non-
maintenance-free or maintenance-free12 V starter
batteries (lead acid batteries) which are used in motor
vehicles. This equipment is also designed for lead gel
batteries.
The equipment may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Mains voltage: 220-240V ~ 50Hz
Rated input current:
Nominal output voltage:
Nominal output current:
Battery capacity at:

5. Before starting the equipment

Most motor vehicle manufacturers recommend
that the battery should be disconnected from the
vehicle's electrical system before being charged.
We would like to point out that even standard
vehicles are fitted with a whole host of electronic
equipment (such as ABS, ASR, injection pump
and on-board computer). Any voltage peaks that
occur may cause defects in these electronic
modules. Therefore the battery should be
disconnected from the electrical system before
being charged.
Please also refer to the instructions in the
owner's manuals for the car, radio, navigation
system, etc.
GB
0.32 A
12 V DC
2 A
3-40 Ah
13