Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Information - EINHELL BT-BC 2 D Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Anleitung_BT_BC_2_D_SPK7:_
GB
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well. We cannot accept any liability for
damage or accidents which arise due to failure to
follow these instructions and the safety information.
Explanation of the warning signs on the
equipment (see Fig. 12)
1 = For indoor use only!
2 = The equipment is totally insulated
3 = CAUTION - Read the operating instructions to
reduce the risk of injury
4 = Read the operating instructions prior to charging;
For indoor use only; Disconnect the charger from
the mains supply before inserting or removing the
battery; CAUTION! Avoid explosive gases,
flames and sparks. Provide good ventilation
during the charging process.

1. Safety Information

Wear safety goggles and gloves when charging
the battery. The caustic acid presents a high risk
of injury.
Do not wear any items of clothing made of
synthetic materials so as to avoid spark formation
caused by electrostatic discharge when charging
the battery.
CAUTION! Explosive gases – avoid flames and
sparks
Disconnect the equipment from the mains supply
before you connect or disconnect the battery.
The charger contains components such as the
switch and fuse which may generate arcs and
sparks. It is essential to ensure that there is good
ventilation in the garage or room.
The charger is suitable for only 12 V lead
batteries.
Do not charge any "non-rechargeable batteries"
or defective batteries.
Refer to the instructions supplied by the battery
manufacturer.
Disconnect the equipment from the mains supply
before you connect or disconnect the battery.
Important. Avoid flames and sparks. Explosive
gas is released during the charging process.
Store the equipment in a dry indoor location only.
Do not place the charger on a heated surface.
12
25.05.2010
9:08 Uhr
Seite 12
Keep the air vents clean.
Caution! Battery acid is aggressive. Should
any acid splash onto hands or clothing, wash
off immediately with soap solution. Should
any acid splash into your eyes, wash it out
immediately with water (for 15 minutes) and
seek the advice of a doctor.
Do not charge any non-rechargeable batteries.
Refer to the information and instructions provided
by the vehicle manufacturer relating to charging
the battery.
Do not charge more than one battery at any one
time.
Do not short circuit the charger clamps.
The mains connection lead and the charging
cables must be in perfect condition.
Keep children away from the battery and charger.
Important. If you smell an acrid odor of gas,
this indicates that there is an acute danger of
explosion. Do not switch off the device. Do
not remove the charger clamps. Ventilate the
room immediately. Have the battery checked
by customer service staff.
Do not use the cable for purposes other than that
for which it is designed.
Do not carry the charger by its cable and do not
use the cable to pull the plug out of the socket.
Protect the cable from heat, oil and sharp edges.
Check the equipment for damage. Unless
otherwise stated in the operating instructions,
defective or damaged parts must be repaired or
replaced by a customer service workshop.
Only ever use the supply voltage specified (220-
240V ~ 50Hz).
Keep the connectors clean and protect them from
corrosion.
Disconnect the equipment from the mains supply
before starting any cleaning or maintenance
work.
Wear acid-resistant gloves and safety
goggles when connecting and charging the
battery and when topping up the battery with
acid or distilled water.
Check the mains cable for signs of damage or
wear at regular intervals and replace if necessary.
Use only PVC hose cables (H03VV).
If the power cable for this machine is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to
avoid danger.
Important. Do not exceed the charging time.
After the end of the charging time pull the plug out
of the socket and disconnect the charger from the
battery.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

10.021.50

Inhaltsverzeichnis