• This appliance is produced to be used
in homes and it can only be used in
domestic environments and for the
specied purposes. It is not suitable for
commercial or common use. Such use will
cause the guarantee of the appliance to
be cancelled and our company will not be
responsible for the losses to be occurred.
• This appliance is produced to be used in
houses and it is only suitable for cooling
/ storing foods. It is not suitable for
commercial or common use and/or for
storing substances except for food. Our
company is not responsible for the losses
to be occurred in the contrary case.
2. INSTALLATION
2.1. Installation instaructions and door
reversibility
Before installation, read the instructions
carefully.
Fit the refrigerator/freezer in stable kitchen
units only.
If necessary, reverse the door according to
instructions.
1. See g.A for the necessary attachment
components.
2. Insert trim ap
1
into slot and screw by
screws
. (g.D)
6
3. Pass the power cord through ventilation
shaft and position it so that the appliance
could be easily plugged in once it has
been installed. (g.B - g.C)
4. Take out the trim gasket
side panel of the appliance and stick it
on reverse side of the door hinges of the
appliance. (g.D - g.E)
5. Raise the appliance and slide into the
kitchen unit.
6. Push the appliance to the reverse side
of the door hinges providing that the trim
gasket
2
covers the space between the
appliance and the kitchen unit.
7. Align the front feet with front surface of
the kitchen unit. (g.F)
located on the
4
EN - 25
8. Screw the front feet by using screws
(g.F)
9. Screw trim ap
to kitchen unit using
1
screws
5
. (g.G)
10. Screw guides
3
to appliance door with
6
screws
. (g.H)
11. Lean appliance door to unit door as it is
opened at right angle.
12. Slide rails
into guides
4
groove. (g.H)
13. Screw the rails
4
screws
. (g.H)
5
14. Set 1~2 mm gap on handle side
between unit itself and unit door by
adjusting guides
3
appliance performance. (g.H)
aligning the
3
to the unit door with
. That is vital for
5
.