Installation Warnings - Telefunken Tfevks123X10A++ Bedienungsanleitung

by the manufacturer, its service agent or similar
qualied persons in order to avoid a hazard.
• This appliance is not intended for use at altitudes
exceeding 2000 m.

1.2. Installation Warnings

Before starting to use your fridge, you
should pay attention to the following points:
• The operating voltage for your fridge is
220-240 V at 50Hz.
• The plug must be accessible after
installation.
• Your fridge may have a smell when it is
operated for the rst time. This is normal
and the smell will fade away when your
fridge starts to cool.
• Before connecting your Fridge, ensure
that the information on the data plate
(voltage and connected load) matches
that of the mains electricity supply. If in
doubt, consult a qualied electrician.
• Insert the plug into a socket with an
efcient ground connection. If the socket
has no ground contact or the plug
does not match, we recommend that
you consult a qualied electrician for
assistance.
• The appliance must be connected with
a properly installed fused socket. Power
supply (AC) and voltage at the operating
point must match with the details on
the name plate of the appliance (name
plate is located on the inside left of the
appliance).
• We do not accept responsibility for any
damages that occur due to ungrounded
usage.
• Place your fridge where it will not be
exposed to direct sunlight.
• Your fridge should never be used
outdoors or exposed to rain.
• Your appliance should be at least 50 cm
away from stoves, gas ovens and heater
cores, and at least 5 cm away from
electrical ovens.
• When your fridge is placed next to a deep,
there should be at least 2 cm between
them to prevent humidity forming on the
outer surface.
• Do not place heavy items on the
appliance.
• Clean the appliance thoroughly, especially
the interior, before use (see Cleaning and
Maintenance).
• The installation procedure into the kitchen
unit is given in the Installation Manual.
This product is intended to be used in
proper kitchen units only.
• Use the adjustable front legs to make
sure your appliance is level and stable.
You can adjust the legs by turning them
in either direction. This should be done
before placing food in the fridge.
• Before using your fridge, wipe all parts
with a solution of warm water and a
teaspoon of sodium bicarbonate, then
rinse with clean water and dry.
• Place all parts in the fridge
after cleaning.
• Install the plastic distance
guide (the part with black
vanes at the rear) by
turning it 90° (as shown in
the gure) to prevent the
condenser from touching the wall.
• The refrigerator should be placed against
a wall with a free space not exceeding 75
mm.
• When using your fridge for the rst time,
or after transportation, keep it in an
upright position for at least 3 hours before
plugging into the mains. This allows
efcient operation and prevents damage
to the compressor.
EN - 18