Kinderkraft KKWMOOV Bedienungsanleitung Seite 13

Adjusting the carrying handle
The carrying handle has 3 positions (J). Press the two buttons (14) on either side of the
carrying handle simultaneously and move the carrying handle forwards or backwards as
required. The buttons will pop out automatically when the carrying handle is in the correct
position (J).
1 Carrying position/car position,
2 Sleeping position/rocking position,
3 Sitting position
6. Care instructions
Cleaning of the shell: The shell may be cleaned with warm water and a gentle soap.
Washing the cover
Take off the cover by loop from plastic pin(K).
The cover must be washed by hand at a maximum temperature of 40°(see washing
instructions on the back of the cover). Do not use a tumble dryer.
Removing the cover for washing. Unhook the cover from behind the pins underneath the
front of the shell. Release elastic straps located on the sides of the shell by the carrying
handle (fig I).
Threat the shoulder belt and buckle carefully through the slots in the cover.
The cover can be refitted by using the above instruction in the reverse order. Check that the
cover is correctly refitted around the edges of the shell.
Note! NEVER remove the energy absorbing foam.
Notice
1. This is a 'Universal' child restraint. It is approved to Regulation No 44, 04 series of
amendments, for general use in vehicles and it will fit most, but not all, car seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook
that the vehicle is capable of accepting a 'Universal' child restraint for this age group.
3. This child restraint has been declared 'Universal' under more stringent conditions than
those which applied to earlier designs which do not carry this notice.
4. If in doubt, consult either the child restraint manufacturer or the retailer.
Only suitable if the approved vehicles are fitted with 3-point with retractor safety-belts,
approved to UN/ECE Regulation No 16 or other equivalent standards.
EN
13