Kinderkraft KKWMOOV Bedienungsanleitung Seite 12

EN
Insert both tongue sections in the buckle, you will hear a loud click locking them in position
(A).
Pull the adjuster belt at the front of the shell tight, so that the child is firmly secured with the
harness belt (the belt system).
Adjusting the harness belt
The harness belt (belt system) must be adjusted to suit your child's body(D).
The harness shoulder belts must be threaded through the slots nearest to the shoulders of
the child (C).
Adjust the harness shoulder belts as follows:
Pull the shoulder belts through the slots in the cover and the shell (C).
Thread the shoulder belts through the correct slots in the shell and cover (C).
Alter the adjuster belt (belt system) as follows:
To loosen:
Press the adjuster button at the front of the shell (B).
Pull both harness shoulder belts simultaneously towards you (B).
To tighten:
Pull the adjuster belt at the front of the shell tight until the harness belt lies firmly against
the child.
The end of the adjuster belt can be fastened on to the hooks at the front of the shell.
5. Using the car safety seat in the car
Please pay attention to the following when installing the cat safety seat in the car.
DO NOT use a child safety seat in seating positions where an active frontal airbag installed.
This can be dangerous. This does not apply to so-called side airbags.
Note the difference between the lap belt and the shoulder belt when installing the seat in
the car.
Always place the seat in a rearward facing position on the passenger seat or back seat, the
carrying handle must be placed in an upright position (E).
If the passenger seat belt is adjustable in height, place it in the lowest position.
Ensure that the front seat is in the rearmost position.
Guide the lap belt of the 3-point seat belt through the blue marked belt hooks on the front
and through the lap belt hooks. Fasten the seat belt into the buckle (F).
Place the car shoulder belt around the back of the seat and hook it into the bright blue
marked belt hook at the rear (G). Ensure that the car shoulder belt is behind the blue belt
hook and blocked by the retaining hook (H). Pull the belt tight. Ensure the belt is not twister.
Double check that the seat belt is threaded correctly through and underneath the three
points marked bright blue (I). The car safety seat is now correctly installed.
12