What If There Are Problems - Beurer Janosch JBY 93 Gebrauchsanweisung

14

What if there are problems?

Faults
Power LED does
not light up after
switch-on
An acoustic signal
comes from the par-
ent unit
The signal is weak,
the connection keeps
breaking up or there is
interference
32
actions
Check whether
• the relevant power supply unit is correctly
connected.
• the batteries are full or the rechargeable bat-
tery needs charging or is damaged.
Check whether
• the maximum range has been exceeded.
• the power supply unit for the baby unit is cor-
rectly connected.
• the baby unit is switched on.
• the batteries are full or the rechargeable bat-
tery needs charging or is damaged.
• If another technical device such as a micro-
wave is in the area between the parent and
baby units, remove the device or switch it off.
• Check whether other factors, such as trees or
anything else, are in the area between the de-
vices, and change the position of the devices
until the parent unit signals a connection.
• Check whether the baby and parent units are
inside the respective receiving range.