Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Stand-Alone Operation; Master/Slave Operation; Control Board - EuroLite 42103487 Bedienungsanleitung

Led stp-10 10x3w 6/25 dmx ww/cw
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the device to the mains, it starts running.
The display lights up and you can choose the desired operating mode via the MODE button:
- STAND-ALONE
- AUTO
- SOUND-CONTROL
- DMX
- MASTER/SLAVE

Stand-alone operation

In the Stand-alone mode, the device can be used without controller. Disconnect the device from the
controller.
Please refer to the instructions under Control Board.

Master/Slave operation

The Master/Slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the EUROLITE LED STP-10 10x3W you can find an XLR-jack and an XLR-plug, which
can be used for connecting several devices.
This device then works as master device and controls the slave devices, which are to be connected to the
master device via a stereo shielded cable. Connect the DMX OUT jack with the DMX IN plug of the next
device.
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please refer to the instructions under Control Board.

Control Board

The Control Board offers several features: you can e. g. simply set the starting address or run the internal
programs.
The main menu is accessed by pressing the Mode button. You can change the selection by pressing Up or
Down. You can leave every mode by pressing the Mode button. The functions provided are described in the
following sections.
24/30
00057075.DOC, Version 1.1

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

421034884210348942103490

Inhaltsverzeichnis