Fuel Filter; Use Of Harness; Technical Specifications; Standard Warranty Terms And Conditions - Texas A/S BCP 4300 Bedienungsanleitung

If you need to adjust the "L" and/or "H" mixture screw
contact with you dealer/service center for some help.

Fuel filter

When the engine runs short of fuel, check the fuel cap
and the fuel filter for blockage/dirt, and clean it before
new mixed fuel is added. See Fig. 20.

Use of harness

When using the brush cutter, it must always be hooked
securely to the harness. Otherwise you will be unable to
control the brush cutter.
The harness should be hooked to the suspension plate
(Fig. 1-19) on the brush cutter.
When using the harness, the weight is evenly
distributed across both shoulders (Fig. 21).
Adjust/tight the harness so it fits properly and feels
comfortable.
Adjust the shoulder strap so that the cutting attachment
is prarallel to the ground (Fig. 22).
Let the cutting attachment rest lightly on the ground
(Fig. 23). Adjust the position of the suspension ring to
balance the brush cutter correctly

Technical specifications

Model
Engine
Rotations per minut
Working width
Fuel tank
Weight
Noise
BCP 4300
43 cc / 1.25 kW (7.000 rpm)
Max 9,500 rpm (blade)
Max 8,500 rpm (nylon line)
25.5 / 43 cm (klinge/snøre)
0.6 liter
9.8 kg
113 dB(A)

Standard warranty terms and conditions

The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Restrictions and requirements
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT covered for more than
12 months:
•
Blades
•
Spools with nylon line (trimmerheads)
•
Cables
•
Switches
•
Membranes/gaskets
•
Spark plugs
•
Engine liquids (oil, gasoline, grease)
•
Starter cords
•
Filters
If you start the engine without adding correct fuel mix of
gasoline and 2-stroke oil, it will be damaged and cannot
be repaired and therefore not covered by the warranty.
The warranty does NOT cover damages/faults
caused by:
•
Lack of service and maintenance
•
Structural changes
•
Exposure to unusual external conditions
•
Damages to the bodywork, deck, handles, panels
etc.
•
If the machine has been improperly used or
overloaded
•
Wrong use of oil, gasoline, grease or other liquid
types, which are not recommended in this user
manual
•
Bad or dirty gasoline, which results in
contamination of the fuel system
•
Use of unoriginal spare parts.
•
Other conditions where Texas cannot be held
responsible.
Whether a case is a warranty claim or not is
determined in each case by an authorized service
center.
Your receipt is your warranty note, why it should
always be kept safe.
REMEMBER: The purchase of spare parts as well as
any request for warranty repair, model number, year
and serial number should always been informed. It can
be found on the CE-label on the machine!
* We reserve the right to change the conditions and
accept no liability for any misprints
16