Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26

8. Fuel

This product has a 2-stroke engine which needs 2-stroke lubricating oil mixed with
-
gasoline.
Always use unleaded gasoline (minimum octane 95)
-
Never use pre-mixed gasoline from gas stations intended for scooters, motorbikes
-
etc.
Always follow the oil manufacturer's instructions for mix ratio (see back of flask).
-
-
Use an approved gas can to mix gasoline and oil.
Use an approved 2-stroke oil for air-cooled engines, chain saws, trimmers and the
-
like. (Do not use outboard- or car lubricating oils). Mix in small amounts.
Texas recommends Texas Motex 2TX at a mix ration of 2%. This is equivalent to
-
0.1 L
2-stroke oil mixed with 5 L gasoline. If using any other oil, ratio should be 4%.
Always follow the manufacturer's instructions.
Mix oil and gasoline thoroughly and shake the can before filling.
-
-
NEVER use a gasoline mixture more than 90 days old, as this can cause starting
problems. Never keep the same gasoline mix in the tank for more than 30 days.
-
Always drain tank prior to long-term storage.
Filling gasoline – No smoking!
Remove filler cap slowly. Place on a clean surface.
Carefully pour fuel mix into tank. Avoid spilling.
Replace and tighten filler cap immediately. Wipe up spilt fuel.
NB: Always switch engine off before filling. Never pour fuel into a machine which is running
or when engine is hot. Move machine at least 3 meters away from filling site before
starting engine. Allow engine to cool for at least 2 minutes before fuelling.
Fuelling (NO SMOKING)
-
1. Always mix and store fuel in an approved container.
2. Always mix fuel outdoors away from sparks or flames.
3. Choose an open space, switch off engine and allow to cool for at least 2
minutes before fuelling.
4. Slacken filler cap slowly to release pressure and avoid fuel brimming over
under cap.
5. Wipe any spilt fuel off machine. Move machine at least 3 meters away from
filling site before starting engine.
Check oil level in air filter.
If necessary top up. - see item 10.
www.texas.dk
20

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Bcx 300Bcx370Bcx430Bcx 320Bc 300Bc 320

Inhaltsverzeichnis