Product Introduction - Edgeendo Edgepack Gebrauchsanweisung

1 Product introduction

1.1 Intended use
It is used to provide heat to the Work Tip, cut the gutta-percha point, and
soften and pressurize the gutta-percha. And the applied part is Work Tip.
1.2 Diagram of components and control buttons
1. "ON/OFF" button
3. Work Tip Protector
5. Connecting hole for power adapter
7. Battery level
9. Battery cartridge
11. Power adapter plug
1 ) "ON/OFF" button:
Under shutdown state, shortly press "ON/OFF" button to start the device.
Under shutdown state, long press "ON/OFF" button to start the device and
change the direction of screen display, that is to say, the direction of display
can be change to adapt to the operation in left hand or right hand.
Under ON state, long press "ON/OFF" button to shut down the device. (Time
for long press is about 1s.)
Note: If there is no operation for 10 minutes, the Heating and Packing In-
strument will automatically shut down.
2. Heating button
4. Work Tip
6. Temperature Level
8. Charging base
10. Charging indicator
12. Power adapter unit
1