Rotel RB-980BX Bedienungsanleitung Seite 3

STEREO POWER
INTRODUCTION
We at Rotel want to thank you for purchasing
product.
Rotel audio products are designed to use the latest electronic
technology, and they incorporate
specialist manufacturer of audio equipment. We are confident
that you will find satisfaction in the high quality sound and
top performance, and that you will find pleasure in the func-
tional beauty achieved through human-engineering concept.
Before starting operation, please read this instruction manual
thoroughly and acquaint yourself with the proper mode of us-
ing the unit and all its connections.
We hope you will enjoy top-notch performance for many years
to come,
BEFORE ENJOYMENT/POWER
Follow the instructions below for maximum safety:
1. Use a wall outlet for power supply
Be sure to connect the AC line cord
let. Be certain that the outlet voltage matches the electrical
rating of the unit, found on the rear panel name plate.
2. Connecting and removing AC cord
Be sure to connect or disconnect the AC line cord only after
turning off the power switch to prevent possible
or damage to the speakers.
3. Ventilate the unit well
Never block any ventilation holes at the top and bottom of the
unit. Be sure also to provide ample ventilation space around
the unit. Poor ventilation may result in damage due to exces-
Sive heat.
4. Do not open the cabinet
In order to avoid electric shock or damage to the component,
never open the cabinet. If a foreign object falls inside the unit
by mistake, turn the power off, disconnect the wall plug, and
consult a qualified electrician
AMPLIFIER RB-980BX
our audio
our long experience
SUPPLY
to a house-hold wall
shock noise
or your dealer.
5. Installation
Be sure to place the unit in a level and flat place where it is
free from humidity,
posed to direct sunlight.
Be careful not to place the unit in a highly enclosed place such
as a as near a wall or on a bookshelf. A poor ventilation will cause
undesirable
6. Moving the unit
When transporting, remove the AC cord from the wall outlet
and all other connected
wire breakage
7. If the unit gets wet
If the unit should get wet, immediately disconnect the AC cord,
and consult your dealer or a qualified electrician.
8. Cleaning
Do not use chemicals
panel. Always use a soft, dry cloth to clean the unit.
9. Owner's
Keep the owner's manual near the unit, and record the serial
number (found on the rear panel) on the cover.
out-
SPEAKERS
When using the RB-980BX as a stereo power amplifier, please
use a speaker system with an impedance range of 4-16 ohms.
When using this unit as a monaural
a bridged (BTL) configuration,
with an impedance
impedance specifications
of the speakers or in the user's manual. Please check to be
sure they are of the correct impedance.
CABLES
To ensure that the RB-980BX operates at its full potential and
you can enjoy the most exceptional
system, we strongly recommend using high-quality RCA pin
cables to connect the RB-980BX to the control amplifier and
low-capacity,
vibration, high temperature
effects to the unit.
cords on the rear panel to prevent
and short circuits.
and maintenance
such as benzine or thinners
manual
amplifier
please use a speaker system
range of 8-16 ohms. The speakers'
can be found on the plate at the rear
sound quality from your
low-impedance speaker cables.
and not ex-
on the front
connected in
2