Mounting - eQ-3 MAX! Eco Bedienungsanleitung

ting the new ones.
• You can now enter two LR03 batteries (Micro/AAA) into
the battery compartment, making sure
they are the right way round according
to the drawings.
• Put the electronic unti back into the
frame.
An empty battery symbol (
cates that the batteries need to be
replaced. If, in addition, a V or S are displayed, the
batteries of a taught-in Heating Thermostat (V) or
Window Sensor (S) have to be replaced.
Never recharge standard batteries. Doing so will pre-
sent a risk of explosion. Do not throw the batteries
into a fire. Do not short-circuit batteries.
Used batteries should not be disposed of with
regular domestic waste. Instead, take them to
your local battery disposal point.
You can either use screws or adhesive strips to mount the
MAX! Eco switch to a wall in the frame supplied or integrate
it into an existing switch (please refer to sec. 10).
Adhesive strip mounting:
• Choose a site for installation. The surface on which you
are mounting the MAX! Eco switch must be clean, dry
and greaseless.
• For mounting of the assembled MAX! Eco switch, attach

6. Mounting

) indi-
17