DeFelsko PosiTector Dew Point Meter Logger Plus Bedienungsanleitung Seite 3

PosiTector DPM L+ probes are designed to be used with the
PosiTector App.
To power up the PosiTector DPM L+ probe unscrew the top cover
(counter clockwise), then press and hold the power button until the
LED indicator turns Solid White. Replace the top cover.
The probe is now visible to the PosiTector App within 10 m (30
feet). The probe will not begin logging until Logging Mode (pg. 6)
is enabled from the PosiTector App, and will not remotely sync data
to PosiSoft.net until WiFi has been configured in the PosiTector
App menu (pg. 4).
NOTE:
Once Logging Mode is enabled, the PosiTector DPM L+
probe will continue to log readings unattended while disconnected
from the PosiTector App. If WiFi has been configured, readings will
be synced to PosiSoft.net at the Sync Interval.
To power down the probe, unscrew the top cover, press and hold
the power button for 5 seconds until the LED indicator turns Solid
Red, and then release the button.
The LED indicator may flash different colors, depending on the
status of the probe.
Solid White
Flashing White Probe attempting to communicate with
Flashing Green Sync with PosiSoft.net successful
Flashing Red
Flashing Blue
Solid Red
Quick Start
LED Indicator
Power button pressed and probe is ON
PosiSoft.net
Error communicating with PosiSoft.net
Probe connected to PosiTector App via
Bluetooth
Probe powering down due to low battery, or
when the power button is pressed for 5
seconds and then released
2