Renkforce RF-TURBD-010 Bedienungsanleitung Seite 47

a
The volume on the audio output device (e.g., amplifier, speakers) has been
lowered.
1. Switch the POWER switch ON.
2. Place the record on the mat so the center hole aligns with the spindle. Use the
45 RPM spindle adaptor if playing a 45 RPM record.
3. Remove the cartridge guard and release the clamp from the tonearm.
4. Select a platter speed by pressing the button marked 33 (33-1/3) or 45.
5. Press the PLAY button to start the platter spinning.
6. Use the tonearm control lever to raise the tonearm UP.
7. Use the handle to position the tonearm over the desired location (groove) on
the record.
8. Use the tonearm control lever to lower the tonearm DOWN.
à
The tonearm will gently descend onto the record and playback will begin.
Adjust the volume as needed.
9. When finished, press the PAUSE button to stop the platter spinning.
10. Lower the volume on the audio output device.
11. Use the tonearm control lever to raise the tonearm UP.
12. Use the tonearm control lever to return the tonearm to the rack and secure it
using the clamp.
13. Remove the record after the platter has come to a complete stop.
14. Switch the POWER switch OFF.
47