Renkforce RF-TURBD-010 Bedienungsanleitung Seite 45

10.3 Adjust the anti-skate
The stylus should sit perfectly in the center of the groove when the record is spin-
ning.
Adjust the anti-skate to prevent the stylus from excessively pushing against the in-
side or outside of the groove.
If the anti-skate is not set correctly it can affect audio quality and damage the re-
cord and stylus.
Preconditions:
a
The tonearm is balanced, see section:
a
The tracking force has been set, see section:
1. Adjust the anti-skate control dial so that it matches the tracking force.
2. Listen carefully to a record to determine if more or less anti-skate is needed.
Anti-Skate
Too little
Too much
Tip:
For more accurate results, use an anti-skate calibration record (not included in
the scope of delivery).
Result
excessive stylus pressure on re-
cord groove inner wall.
excessive stylus pressure on re-
cord groove outer wall.
Balance the tonearm
Set the tracking force
Feedback
Right audio channel distor-
tion.
Left audio channel distor-
tion.
[} 43].
[} 44].
45