Renkforce RF-TURBD-010 Bedienungsanleitung Seite 30

Table of Contents
1 Introduction ...............................................................................................
2 Intended use.............................................................................................
3 Delivery contents ......................................................................................
4 Latest product information ........................................................................
5 Description of symbols..............................................................................
6 Safety instructions ....................................................................................
6.1 General.........................................................................................
6.2 Handling .......................................................................................
6.3 Operating environment.................................................................
6.4 Operation......................................................................................
6.5 Mains cable ..................................................................................
6.6 Connected devices.......................................................................
6.7 Photosensitive epilepsy................................................................
7 Product overview ......................................................................................
7.1 Turntable (top)..............................................................................
7.2 Turntable (side) ............................................................................
7.3 Tonearm.......................................................................................
7.4 Additional information...................................................................
8 Choosing a location ..................................................................................
9 Assembly and connection.........................................................................
9.1 Overview of steps.........................................................................
9.2 Level the turntable........................................................................
9.3 Set the platter on the spindle........................................................
9.4 Attach the drive belt to the motor pulley.......................................
9.5 Place the felt mat over the platter.................................................
9.6 Assemble the tonearm .................................................................
9.6.1
9.6.2
30
Attach the headshell to the tonearm ...........................
Attach the counterweight.............................................
32
32
33
33
33
33
33
34
34
34
35
35
36
36
36
37
37
38
38
39
39
39
40
40
40
41
41
41