Meec tools R6218CP Originalanweisungen Seite 22

2
Put the mixer rod in the chuck. Make sure that the
small tap fits in the slot on the chuck, if not the mixer
rod will come loose. (Figure 3)
3
Release the chuck and make sure that the mixer rod
is in the correct position. (Figure 4)
4 Operation
4.1 To operate the product
Warning! Make sure that the power switch is working
correctly before you use the product.
1
Connect the power plug to a power outlet.
2
Push and hold the power trigger lockout.
3
Push the power trigger to start and run the product.
4
Push the power trigger lockout and release the power
trigger to let the product run continously.
5
Push and release the power trigger to stop the
product.
4.2 To adjust the speed manually
1
Stop the product.
2
Select a speed with the switch. (Figure 5)
Note! If a speed cannot be selected with the switch, move
the mixer rods manually and try again.
4.3 To adjust the speed electronically
1
Start the product.
2
Increase or decrease the speed with the electronic
speed control. (Figure 6)
5 Maintenance
5.1 To clean the product
Caution! The chucks for the mixer rods must be cov-
ered by the safety caps when the mixers are not fitted.
● Clean the product with water or sand after each use.
● Clean the ventilation openings from debris and other
deposits to prevent damage and the risk of fire.
22
5.2 To do maintenance on the product
● Examine the carbon brushes after 60 hours of use.
Replace the carbon brushes if they are worn or has
damage..
6 Disposal
6.1 To discard the product
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
7 Technical data
Specification
Voltage
Power
Cord length
Dimensions
Weight
Noise levels
Sound pressure level, LpA
Measure sound power level, LwA
Maximum vibrations level
1
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level when
using tools may differ from the specified maximum value,
depending on how the tool is used and the material. It is
therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of
exposure in actual operating conditions (taking into account
all stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the start-up
time).
1 The declared values for vibration and noise, which have
been measured according to a standardized test method,
can be used to compare different tools with each other and
for a preliminary assessment of exposure. The measurement
values have been determined in accordance with
EN 62841-2-10:2017.
Value
230 V~50 Hz
1600 W
2 m
L92 x W30 cm
6.8 kg
84 dB(A), K=3
95 dB(A), K=3
4.21 m/s2, K=1.5 m/s2