Meec tools R6218CP Originalanweisungen Seite 19

Table of contents
1 Introduction
1.1 Intended use ............................................................7
1.2 Symbols ......................................................................7
1.3 Product overview...................................................7
2 Safety
2.1 Safety definitions ...................................................7
2.2 Safety instructions for operation ...................8
3 Assembly
3.1 To assemble the product ...................................9
4 Operation
4.1 To operate the product .....................................10
4.2 To adjust the speed manually........................10
4.3 To adjust the speed electronically...............10
5 Maintenance
5.1 To clean the product ..........................................10
5.2 To do maintenance on the product ............10
6 Disposal
6.1 To discard the product ......................................10
7 Technical data
1 Introduction
1.1 Intended use
7
The product is used to mix paint, concrete and mortar.
1.2 Symbols
7
9
10
10
10
10
1.3 Product overview
Figure 1
1. Motor casing
2. Switch mode I/II
3. Chuck M16
4. Mixer
5. Electronic speed control
6. Power trigger lockout
7. Power trigger
2 Safety
2.1 Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
Protective earthing.
Wear a dust filter mask.
Wear safety glasses and ear protection.
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
19