Meec tools ST2502R Bedienungsanleitung Seite 23

Wear a face mask.
Safety class II
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Output
Speed
Sandpaper size
Cord length
Sound pressure level, LpA: 76.0 dB(A), K= 3 dB
Sound power level, LwA:
Vibration level:
Always wear ear protection!
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN 62841-2-4:2014.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
230 V ~ 50 Hz
280 W
6000-13000 rpm
125 mm
1.8 m
87 dB(A), K= 3 dB
6.1 m/s2, K= 1.5 m/s2
DESCRIPTION
Sander with dust collector for dustless sanding,
which means it can be used both indoors and
outdoors. Rubber coated grips for safe grip
and Velcro fastener for simple replacement of
sanding discs. One sanding disc (Ø125 mm,
G80) included.
Parts
1. Power switch
2. Dust bag
3. Speed setting
4. Sanding pad
FIG. 1
ASSEMBLY
FITTING THE SANDPAPER
1. Put the required grade of sandpaper on
the pad (4).
2. Align the holes in the sandpaper to the
dust extraction holes in the sanding pad.
3. Fold both ends of the sandpaper round
the edges of the pad. Clamp the ends of
the sandpaper firmly in place with the
clips.
WARNING!
The sandpaper should fit firmly, so that it
cannot come loose.
USE
STARTING / STOPPING
1. Start the product by pressing the power
switch (1).
2. Switch off the product by releasing the
power switch.
WARNING!
Never sand anything containing magnesium.
EN
23