Positioning The Grill; Before Grilling - tepro BILOXI Bedienungsanleitung

Positioning the grill

Attention Risk of damage!
During use, the screws can
loosen slowly and impair the
grill's stability.
– Check the stability of the screws prior
to each use. If necessary, tighten all of
the screws again to ensure the smoker
is standing securely.
• Before use, place the grill on an even,
sturdy surface outdoors.

Before grilling

Danger Risk of burning!
The grill, the charcoal and grill
meat become very hot during
use. Any contact can result in
serious burns.
– Keep the charcoal in the small grill
chamber at a sufficient distance from
the air vent so that no embers or hot
charcoal can fall out of the grill chamber.
Danger Health risk!
Do not use any charcoal that
has been pretreated with lighter
fluid. Use only pure, high-
quality charcoal or a mixture of
charcoal and wood.
P140038_TEPRO_BILOXI_GrillSmoker_1087_20151118.indb 33
Attention Risk of damage!
In order to prolong the service
life of the grill, ensure that the
hot coals and the burning wood
do not come into direct contact
with the walls of the grill.
– Do not rub or scratch the external
housing of the hot grill during the initial
heating treatment.
• Prior to first use, the grill must be
oiled and then heated through for at
least 3 hours to protect the housing
from heavy rust and to burn off
production residues.
Important: The grill should always
be stored in an oiled condition and
covered up.
• Wash down the grill grate with warm,
soapy water. Then rinse it with clean
water and dry it off.
• Rub the external surfaces of the grill
with vegetable oil or use a vegetable oil
for spraying. Do not treat the charcoal
grate and the ash tray with vegetable
oil.
• A collection container (e.g. a can) must
always be placed in the grease can
holder (34).
• Follow the instructions for lighting the
grill. You can use charcoal or wood.
• Start with approx. 2 kg of charcoal. This
quantity should be sufficient for the
primary heating treatment.
• Pour sufficient lighter fluid over the
charcoal, in accordance with the
manufacturer specifications. With the
covers open, wait approx. 2-3 minutes
until the fluid has worked its way
in. Alternatively, you can use solid,
commercial firelighters.
t
33
18/11/15 3:36 PM